MPEG LA MPEG4 Instrukcja Użytkownika Pobierz pdf (Strona 10)

CONNECTIONS AND SETUP

-6-

3. CONNECTIONS AND SETUP

3.1 HDD Installation

The HDD must be installed before the DVR is turned on.

Step 1: Loose the screws on the upper cover and open the upper cover of the DVR.

Step 2: Remove the HDD bracket.

Step 3: Get a suitable brand HDD and set the HDD mode to “Master” mode.

Step 4: Slide and fasten the HDD to the HDD bracket, two screws for each side.

Step 5: Replace the HDD bracket back to the DVR base.

Step 6: Connect the HDD to the power connector and the IDE BUS connector

(make sure to align the HDD precisely for pin connection).

Step 7: Close the upper cover of the DVR, and fasten all the screws you loosened in Step 1.

3.2 Camera Connection

The cameras must be connected and power-supplied BEFORE the DVR is turned on. The DVR will automatically

detect the video system of the connected camera(s) (NTSC / PAL), and switch itself to the correct system.

Connect the camera with the indicated power supply, and connect the camera video output to the DVR video input

port with a coaxial cable or RCA lines with BNC connectors.

Note: For detailed DVR video input / output ports, please refer to “2.2 Rear Panel” at page 5.

For detailed camera operation, please refer to its own manual.

Note: If you want to make a video backup with audio, please connect audio camera to the CH1 which

support the audio function

3.3 Power Setup

This device should be operated only with the type of power source indicated on the manufacturer’s label. Connect

the indicated AC power cord to the power adapter, and plug into an electrical outlet. The power LED “ ” will be on as

green. It takes approximately 10 to 15 seconds to boot the system.

3.4 Date and Time Setting

Before operating your DVR, please set the date and time on your DVR first.

Press the “MENU” button and enter the password to go to the menu list. The default admin password is 0000.

Move the cursor to “DATE” and you can set the date / time / daylight saving in the “DATE” menu list.

3.5 Password Setting

Press the “MENU” button and enter the password to go to the menu list. Then, move the cursor to “ADVANCE” to

enter the advanced setting menu.

In the “ADVANCE” menu, move the cursor to “SYSTEM”. Select “PASSWORD” and press the “ENTER” button to

enter the submenu to set the password (four digits). The default admin password is 0000.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 59 60

Brak uwag

MPEG LA MPEG4 Instrukcja Użytkownika Strona 10