MPEG LA 4CH Instrukcja Użytkownika Pobierz pdf (Strona 34)

MENU FUNCTION

-30-

6.6.5 PTZ Camera Setup and Control

‧ PTZ connection: Please refer to section “3.2.2 PTZ” at page 8.

‧ PTZ ID, protocol, baud rate setting at the DVR side: Please refer to section “6.4.5 Remote” at page 22.

‧ PTZ ID, protocol, baud rate setting at the remote AP software side:

Please refer to section “(1) Device” at page 39 (AP software system configuration).

‧ PTZ control at DVR side:

Press these

SEQ.

P.T.Z

or two buttons on the DVR front panel at the same time to enter / exit the PTZ control mode.

In the PTZ control mode, press "＋" button to zoom in, press "－" button to zoom out, and press "UP”, “DOWN”, “LEFT”

or “RIGHT" buttons on the DVR front panel to adjust the PTZ angle.

‧ PTZ control at AP software side: Please refer to section “7.3.2 PTZ Camera Control Panel” at page 34.

6.6.6 R.E.T.R. Setup (For Model 5 only)

Before activating the R.E.T.R. function, please set the motion detection area first.

(1) Setup Motion Detection Function:

Activate motion detection function and setup the motion detection area and sensitivity. Please refer to section “6.4.2

Detection” at page 18, or section “(2) Detection” at page 40 (AP software system configuration).

(2) Activate the R.E.T.R. Function:

‧ From DVR front panel:

Press ”Menu” and “－” buttons on the DVR front panel at the same time. R.E.T.R. function will be activated 3 / 5 / 10

minutes later. For detailed instructions, please refer to section “6.4.6 System”. A message “R.E.T.R. ON” will be shown

on the screen (in white text), and after the RETR function is activated, the message “R.E.T.R.” shown on the screen will

turn to red.

‧ From AP software at remote PC/NB side:

Press “R.E.T.R.” button on the AP control panel to activate the R.E.T.R. function immediately. Please refer to section

“7.3.1 DVR Control Panel”.

‧ From IR transmitter:

Press “R.E.T.R.” or “F3” button on the IR remote control to activate the R.E.T.R. function for 3 / 5 / 10 minutes later.

Please refer to the IR transmitter manual.

(3) Turn off the R.E.T.R. Function:

‧ From DVR front panel:

Press any key (except “ ” or “POWER” button) and enter the password to turn off the RETR function.

‧ From AP software at remote PC/NB side:

Press “R.E.T.R.” button on the AP control panel again to turn off the R.E.T.R. function.

‧ From IR transmitter:

Press any key (except “POWER” button) and enter the password to turn off the RETR function.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 59 60

Brak uwag

MPEG LA 4CH Instrukcja Użytkownika Strona 34